clear ethernet cfm local meps
To clear the counters for all MEPs or a specified MEP, use the clear ethernet cfm local meps command in
EXEC mode.
clear ethernet cfm local meps {all| domain domain-name {all| service service-name {all| mep-id id}}|
interface interface-name {all| domain domain-name}}
Syntax Description
Clears counters for all local MEPs.all
String of a maximum of 80 characters that identifies the domain in which
the maintenance points reside.
For more information about the syntax, use the question mark (?)
online help function.
Note
domain domain-name
String of a maximum of 80 characters that identifies the maintenance
association to which the maintenance points belong.
service service-name
Maintenance end point (MEP) ID number. The range for MEP ID numbers
is 1 to 8191.
mep-id id
String of a maximum of 80 characters that identifies the Ethernet interface.
interface interface-name
Command Default
No default behavior or values
Command Modes
EXEC (#)
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The following counters are cleared:
•
Number of continuity-check messages (CCMs) sent
•
Number of CCMs received
•
Number of CCMs received out of sequence
•
Number of CCMs received, but discarded due to the maximum-meps limit
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
168
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
clear ethernet cfm local meps
To Next Page
Loading...
Need help?
General
