show lldp interface
To display Link Layer Discovery Protocol (LLDP) configuration and status information on an interface, use
the show lldp interface command in EXEC configuration mode.
show lldp interface [type interface-path-id | location location]
Syntax Description
(Optional) Interface type. For more information, use the question mark (?) online
help function.
type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router. For more information about the syntax for the
router, use the question mark (?) online help function.
Note
interface-path-id
(Optional) Displays information about LLDP neighbors for the specified location.
The location argument is entered in the rack/slot/module notation.
location location
Command Default
LLDP configuration and status information for all interfaces is displayed.
Command Modes
EXEC (#)
Command History
ModificationRelease
This command was introduced.Release 4.1.0
Usage Guidelines
When LLDP is enabled globally on the system, all supported interfaces are automatically enabled for both
LLDP receive and transmit operations. You can individually disable interfaces for either LLDP receive or
transmit operations using the receive disable command or transmit disable command in LLDP configuration
mode under the interface.
Task ID
OperationTask ID
readethernet-services
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
116
Ethernet Interface Commands on the Cisco ASR 9000 Series Router
show lldp interface
To Next Page
Loading...
Need help?
General
