â—¦
port: Physical port number of the interface.
•
If specifying a virtual interface, the number range varies, depending on interface type.
Task ID
OperationsTask ID
readinterface
Examples
These examples show the outputs from the show mac-accounting command, which displays MAC accounting
statistics on any specified interface:
RP/0/RSP0/CPU0:router# show mac-accounting TenGigE 0/2/0/4 location 0/1/CPU0
TenGigE0/2/0/4
Input (511 free)
000b.4558.caca: 4 packets, 456 bytes
Total: 4 packets, 456 bytes
Table 9: show mac-accounting Field Descriptions
DescriptionField
The interface from which the statistics are generated.Interface
Heading for the ingress MAC accounting statistics.
The number of MAC accounting entries still available
is shown in parentheses.
Input
Total statistics for the traffic accounted for by MAC
accounting. This excludes any traffic for which there
is no MAC address entry, such as non-IP traffic from
an unknown MAC source address. This output also
excludes any MAC addresses that have 0 packets
currently, even if that MAC address was accounted
before. Such type of MAC addresses still contribute
towards the maximum address limit.
Total
Related Commands
DescriptionCommand
Clears MAC accounting statistics for an interface.clear mac-accounting (Ethernet), on page
81
Generates accounting information for IP traffic based on the
source and destination MAC addresses on LAN interfaces.
mac-accounting, on page 99
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
124
Ethernet Interface Commands on the Cisco ASR 9000 Series Router
show mac-accounting (Ethernet)
To Next Page
Loading...
Need help?
General
