multi-router aps
To configure Multi-Router Automatic Protection Switching (MR-APS) and enter APS redundancy configuration
mode, use the multi-router aps command in redundancy configuration mode. To deactivate Multi-Router
Automatic Protection Switching (MR-APS), use the no form of this command.
multi-router aps
no multi-router aps
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
Redundancy configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
readppp
Examples
The following example shows how to
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# redundancy
RP/0/RSP0/CPU0:router(config-redundancy)# multi-router aps
RP/0/RSP0/CPU0:router(config-redundancy-aps)
Related Commands
DescriptionCommand
Enters the redundancy configuration mode to configure MR-APS.redundancy, on page 755
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
718
PPP Commands onthe Cisco ASR 9000 Series Router
multi-router aps
To Next Page
Loading...
Need help?
General
