profile (SLA)
To create an SLA operation profile and enter the SLA profile configuration mode, use the profile command
in SLA configuration mode. To remove the profile, use the no form of this command.
profile profile-name type {{cfm-delay-measurement| cfm-delay-measurement-v0}| cfm-loopback|
cfm-synthetic-loss-measurement}
no profile profile-name
Syntax Description
Profile name, case-sensitive string up to 31 characters in length. The name “all” cannot
be used.
profile-name
Specifies the type of packets sent by operations in this profile. Valid types are:
•
cfm-delay-measurement: CFM delay measurement packets
•
cfm-delay-measurement-v0: CFM delay measurement version 0 packets
•
cfm-loopback: CFM loopback packets
•
cfm-synthetic-loss-measurement: CFM synthetic loss measurement packets
type
Command Default
No default behavior or values
Command Modes
Ethernet SLA configuration (config-sla)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
The cfm-delay-measurement-v0 and cfm-synthetic-loss-measurement
keyword was introduced.
Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Each profile is uniquely identified by its name. Changing the packet type for the profile removes all stored
data from the profile and is equivalent to deleting the profile and creating a new profile.
Note
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
301
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
profile (SLA)
To Next Page
Loading...
Need help?
General
