Command Modes
EXEC (#)
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
If a Local MEP is receiving Wrong Level CCMs, and if the Remote MEP has its CCM processing offloaded,
then the last CCM cannot be displayed.
Note
Task ID
OperationsTask ID
readethernet-services
Examples
The following example shows sample output of MEPs detected by a local MEP:
RP/0/RSP0/CPU0:router# show ethernet cfm peer meps
Flags:
> - Ok I - Wrong interval
R - Remote Defect received V - Wrong level
L - Loop (our MAC received) T - Timed out
C - Config (our ID received) M - Missing (cross-check)
X - Cross-connect (wrong MAID) U - Unexpected (cross-check)
* - Multiple errors received
Domain dom3 (level 5), Service ser3
Down MEP on GigabitEthernet0/0/0/0 MEP-ID 1
================================================================================
St ID MAC Address Port Up/Downtime CcmRcvd SeqErr RDI Error
-- ----- -------------- ------- ----------- --------- ------ ----- -----
V 10 0001.0203.0403 Up 00:01:35 2 0 0 2
Domain dom4 (level 2), Service ser4
Down MEP on GigabitEthernet0/0/0/0 MEP-ID 1
================================================================================
St ID MAC Address Port Up/Downtime CcmRcvd SeqErr RDI Error
-- ----- -------------- ------- ----------- --------- ------ ----- -----
> 20 0001.0203.0402 Up 00:00:03 4 1 0 0
> 21 0001.0203.0403 Up 00:00:04 3 0 0 0
Domain dom5 (level 2), Service dom5
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
340
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
show ethernet cfm peer meps
To Next Page
Loading...
Need help?
General
