lacp system
To set the default system parameters for the Link Aggregation Control Protocol (LACP) bundles, use the lacp
system command in global configuration mode.
lacp system{ mac|priority}
Syntax Description
Unique MAC address used to identify the system in LACP negotiations.mac
Priority for this system. Lower value is higher priority. Range is from 1 to 65535.priority
Command Default
System priority is 32768. MAC address is automatically assigned from the backplane pool.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper task
IDs. If you suspect user group assignment is preventing you from using a command, contact your AAA
administrator.
The parameters are the system MAC address and the priority of the system. The MAC address must be unique
to the system (if it matches a partner system, LACP negotiations fail). The combination of the MAC address
and the set system priority determine the priority of the LACP bundles.
Task ID
OperationTask ID
read, writebundle
Examples
The following example shows how to configure the MAC address on an LACP system:
RP/0/RSP0/CPU0:router(config)lacp system mac 000c.15c0.bd15
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
503
Global Interface Commandsonthe Cisco ASR 9000 Series Router
lacp system
To Next Page
Loading...
Need help?
General
