clear ppp sso state
To clear the replicated Inter-Chassis Stateful Switchover (ICSSO) states for the specified standby interface
or for all interfaces on the specified node, use the clear ppp sso state command in EXEC mode.
clear ppp sso state {interface interface-path-id| all} location node-id
Syntax Description
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark
(?) online help function.
interface interface-path-id
Specifies the full qualified path of a specific node in the format
rack/slot/module.
all location node-id
Command Default
No default behavior or values
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command sets the PPP sessions in the Standby-Up state to the Standby-Down state. All replicated data
received from the peer is purged, and SSRP Request messages are re-sent to the peer.
Task ID
OperationsTask ID
executeppp
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
711
PPP Commands onthe Cisco ASR 9000 Series Router
clear ppp sso state
To Next Page
Loading...
Need help?
General
