show frame-relay lmi
To display Frame Relay statistics for the Local Management Interface (LMI), use the show frame-relay lmi
EXEC command.
show frame-relay lmi [interface type interface-path-id| location node-id]
Syntax Description
(Optional) Interface for which information is to be displayed.Use the
interface-path-id argument to specify the interface.
interface
(Optional) Interface type. For more information, use the question mark (?) online
help function.
type
(Optional) Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
(Optional) Displays information about all interfaces on the specified node. The
node-id argument is entered in the rack/slot/module notation.
location node-id
Command Default
Frame Relay LMI statistics are displayed for all interfaces enabled for LMI.
Command Modes
EXEC (#)
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The show frame-relay lmi command is available on Packet-over-SONET/SDH (POS), serial, and multilink
interfaces.
This command is used to check the status enquiry and status message between DCE and DTE.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
462
Frame Relay Commands on the Cisco ASR 9000 Series Router
show frame-relay lmi
To Next Page
Loading...
Need help?
General
