Examples
The following example shows how to configure the low and high thresholds that trigger a frame-seconds error
event:
RP/0/RSP0/CPU0:router(config)# ethernet oam profile Profile_1
RP/0/RSP0/CPU0:router(config-eoam)# link-monitor (config-eoam)# link-monitor
RP/0/RSP0/CPU0:router(config-eoam-lm)# frame-seconds threshold low 10 high 900
Related Commands
DescriptionCommand
Creates an EOAM profile and enters EOAM configuration
mode.
ethernet oam profile, on page 215
Enters Ethernet OAM link monitor configuration mode.link-monitor, on page 262
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
253
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
frame-seconds threshold
To Next Page
Loading...
Need help?
General
