controller t3
To configure a T3 controller and enter T3 configuration mode, use the controller t3 command in global
configuration mode. To return to the default state, use the no form of this command.
controller t3 interface-path-id
no controller t3 interface-path-id
Syntax Description
Physical interface or virtual interface.
Use the show controllers command to see a list of all controllers currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?) online
help function.
interface-path-id
Command Default
No default behavior or values
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
For the interface-path-id argument, use the following guidelines:
•
When specifying a T3 controller, the naming notation is rack/slot/module/port/T3num. The slash between
values is required as part of the notation. An explanation of each component of the naming notation is
as follows:
◦ rack—Chassis number of the rack.
◦ slot—Physical slot number of the line card or SIP.
◦ module—Module number or subslot (for a SPA). A physical layer interface module (PLIM) is
always 0.
◦ port—Physical port number of the interface.
◦ T3num—T3 controller number.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
976
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
controller t3
To Next Page
Loading...
Need help?
General
