RP/0/RSP0/CPU0:router(config-if-eoam)# profile Profile_1
RP/0/RSP0/CPU0:router(config-if-eoam)# remote-loopback
Related Commands
DescriptionCommand
Creates an EOAM profile and enters EOAM configuration mode.ethernet oam profile, on page 215
Enables Ethernet Link OAM, with default values, on an interface
and enter interface Ethernet OAM configuration mode.
ethernet oam, on page 212
Starts or stops a loopback at the remote end of an Ethernet OAM
interface.
ethernet oam loopback, on page 213
Attaches an Ethernet OAM profile to an interface.profile (EOAM), on page 299
Displays the current active Ethernet OAM configuration on an
interface.
show ethernet oam configuration, on page
366
Displays the current state of Ethernet OAM interfaces.show ethernet oam interfaces, on page 374
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
304
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
remote-loopback
To Next Page
Loading...
Need help?
General
