ppp ipcp peer-address default
To specify the default IPv4 address that is assigned to the peer by the Internet Protocol Control Protocol
(IPCP), use the ppp ipcp peer-address default command in interface configuration mode. To remove the
address, use the no form of this command.
ppp ipcp peer-address default ip-address
no ppp ipcp peer-address default ip-address
Syntax Description
Specifies the IP address for the peer node.
ip-address
Command Default
No default behavior or values
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeppp
Examples
The following example shows how to specifies the default IPv4 address that is assigned to the peer by IPCP.
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# interface serial 0/1/0/1
RP/0/RSP0/CPU0:router(config-if)# ppp ipcp peer-address default 10.10.10.10
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
729
PPP Commands onthe Cisco ASR 9000 Series Router
ppp ipcp peer-address default
To Next Page
Loading...
Need help?
General
