Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to configure the class of service (CoS) for a maintenance end point (MEP)
on an interface.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/0/1
RP/0/RSP0/CPU0:router(config-if)# ethernet cfm mep domain Dm1 service Sv1 mep-id 1
RP/0/RSP0/CPU0:router(config-if-cfm-mep)# cos 7
Related Commands
DescriptionCommand
Enters interface CFM configuration mode.ethernet cfm (interface), on page 209
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
195
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
cos (CFM)
To Next Page
Loading...
Need help?
General
