backbone interface
To configure interchassis group ICCP backbone interface, use the backbone interface command in the
redundancy group ICCP configuration mode. To return to the default behavior, use the no form of this
command.
backbone interface type interface-path-id
no backbone interface type interface-path-id
Syntax Description
Interface type. For more information, use the question mark (?) online help function.
type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?) online
help function.
interface-path-id
Command Default
None
Command Modes
Redundancy group ICCP configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeconfig-services
Examples
This example shows how to configure interchassis group ICCP backbone interface:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# redundancy iccp group 10
RP/0/RSP0/CPU0:router(config-redundancy-iccp-group)# backbone interface GigabitEthernet
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
565
Link Bundling Commands on the Cisco ASR 9000 Series Router
backbone interface
To Next Page
Loading...
Need help?
General
