interface (Ethernet)
To specify or create an Ethernet interface and enter interface configuration mode, use the interface (Ethernet)
command in global configuration mode.
interface {GigabitEthernet| TenGigE} interface-path-id
no interface {GigabitEthernet| TenGigE} interface-path-id
Syntax Description
Specifies or creates a Gigabit Ethernet (1000 Mbps) interface.GigabitEthernet
Specifies or creates a Ten Gigabit Ethernet (10 Gbps) interface.TenGigE
Physical interface.
Use the show interfaces command to see a list of all interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark
(?) online help function.
interface-path-id
Command Default
None
Command Modes
Global configuration (config)
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To specify a physical interface, the notation for the interface-path-id is rack/slot/module/port. The slash
between values is required as part of the notation. An explanation of each component of the naming notation
is as follows:
•
rack: Chassis number of the rack.
•
slot: Physical slot number of the line card.
•
module: Module number. A physical layer interface module (PLIM) is always 0.
•
port: Physical port number of the interface.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
85
Ethernet Interface Commands on the Cisco ASR 9000 Series Router
interface (Ethernet)
To Next Page
Loading...
Need help?
General
