Specifies the ID (from 1 to 8191)
of the target MEP that is known to
the local MEP for the probe.
target mep-id id-number
(Optional) Specifies the type of
statistics to collect:
• one-way-delay-ds—One-way
delay statistics from
destination to source.
• one-way-delay-sd—One-way
delay statistics from source to
destination.
• one-way-jitter-ds—One-way
delay jitter from destination
to source.
• one-way-jitter-sd—One-way
delay jitter from source to
destination.
• round-trip-delay—Round-trip
delay statistics.
• round-trip-jitter—Round-trip
jitter statistics.
All statistics are collected by
default.
statistics measure
(Optional) Specifies that statistics
are not aggregated into bins, and
each statistic is stored individually.
This option can be
memory-intensive and
should be used with
care.
Caution
aggregate none
(Optional) Specifies the number of
bins (from 2 to 100) within each
bucket to store sample packets from
the probe. The default is to
aggregate into one bin.
aggregate bins number
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
227
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
ethernet sla on-demand operation type cfm-delay-measurement probe
To Next Page
Loading...
Need help?
General
