peer ipv4 address
To configure the IPv4 address for a Session State Redundancy Protocol (SSRP) peer, use the peer ipv4
address command in SSRP configuration mode. To remove the address, use the no form of this command.
peer ipv4 address ip-address
no peer ipv4 address ip-address
Syntax Description
IP address of the peer interface whose states will be replicated by SSRP.
ip-address
Command Default
No default behavior or values
Command Modes
SSRP configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeppp
Examples
The following example shows how to configure the IPv4 address for a Session State Redundancy Protocol
(SSRP) peer:
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# ssrp profile Profile_1
RP/0/RSP0/CPU0:router(config-ssrp)# peer ipv4 address 10.10.10.10
Related Commands
DescriptionCommand
Configures a SSRP profile and enters the SSRP configuration
mode.
ssrp profile, on page 774
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
719
PPP Commands onthe Cisco ASR 9000 Series Router
peer ipv4 address
To Next Page
Loading...
Need help?
General
