rtp
To enable Real Time Protocol (RTP) compression and decompression on the interface, use the rtp command
in IPHC profile configuration mode. To remove RTP from the interface, use the no form of this command.
rtp
no rtp
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
IPHC profile configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
RTP can be enabled only within an IPHC profile.Note
You must enable RTP before attaching a profile to an interface. If you do not enable RTP
first, the router will display the following message: ‘!!% 'iphc_capability' detected the
'warning' condition 'IPHC Capability: RTP Compression NOT enabled in the profile'!
Task ID
OperationsTask ID
read, writeip-services
Examples
The following example shows how to
RP/0/RSP0/CPU0:router(config)# config
RP/0/RSP0/CPU0:router(config)# iphc profile Profile_1 type iphc
RP/0/RSP0/CPU0:router(config-iphc-profile)# rtp
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
806
Serial Interface Commands on the Cisco ASR 9000 Series Router
rtp
To Next Page
Loading...
Need help?
General
