require-remote
To require that certain features are enabled before an OAM session can become active, or to disable a
requirement that is part of an active OAM profile, use the require-remote command in Ethernet OAM
configuration or interface Ethernet OAM configuration mode. To remove the configuration and return to the
default, use the no form of this command.
require-remote {mode {active| passive}| mib-retrieval| remote-loopback| link-monitoring [disabled]}
no require-remote {mode {active| passive}| mib-retrieval| remote-loopback| link-monitoring [disabled]}
Syntax Description
Requires that active or passive mode is configured on the peer device before
the OAM profile can become active.
mode {active | passive}
Requires that MIB-retrieval is configured on the peer device before the OAM
profile can become active.
mib-retrieval
Requires that remote-loopback is configured on the peer device before the
OAM profile can become active.
remote-loopback
Requires that link-monitoring feature is configured on the peer device before
the OAM profile can become active.
link-monitoring
(Optional—Interface Ethernet OAM configuration only) Overrides the Ethernet
OAM profile configuration for this option and disables the feature at the
specified interface.
disabled
Command Default
No default behavior or values
Command Modes
Ethernet OAM configuration (config-eoam)
Interface Ethernet OAM configuration (config-if-eoam)
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The disabled keyword is available only when you are configuring Ethernet OAM on an interface, and is used
to override the configuration that is part of an active OAM profile.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
305
Ethernet OAM Commands on the Cisco ASR 9000 Series Router
require-remote
To Next Page
Loading...
Need help?
General
