Command Default
No default behavior or values
Command Modes
STS controller configuration
AU controller configuration
T3 controller configuration
TUG3 controller configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
The pos, tug3, e1, c12, c12-e1, and e3 keywords were supported.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
For channelized SPAs, you must use the mode command before you can configure any channelized controllers.
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows how to set the mode of a T3 controller to channelized T1:
RP/0/RSP0/CPU0:router(config)# controller t3 0/1/0/0/1
RP/0/RSP0/CPU0:router(config-t3)# mode t1
Related Commands
DescriptionCommand
Sets the number of paths in a stream.width, on page 932
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
875
SONET Controller Commands on the Cisco ASR 9000 Series Router
mode (SONET)
To Next Page
Loading...
Need help?
General
