Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows how to enable logging of link noise monitoring events:
RP/0/RSP0/CPU0:router(config)# controller t1 0/6/0/0/1/1
RP/0/RSP0/CPU0:router(config-t1)# lnm syslog
Wed May 12 15:42:54.679 PDT
WARNING: Enabling 'lnm syslog' could result in large amount of messages depending on the
number of links configured.
Related Commands
DescriptionCommand
Configures an E1 controller and enters E1
configuration mode.
controller e1, on page 970
Configures a T1 controller and enters T1
configuration mode.
controller t1, on page 974
Enables link noise monitoring and specifies thresholds
for noise errors on T1/E1 links that are used to signal
major warning events and recovery from those events.
lnm major-warning, on page 1012
Enables link noise monitoring and specifies thresholds
for noise errors on T1/E1 links that are used to signal
minor warning events and recovery from those events.
lnm minor-warning, on page 1015
Displays the contents of the logging buffer.show logging
Displays messages in the logging events buffer.show logging events buffer
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1022
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
lnm syslog
To Next Page
Loading...
Need help?
General
