The following example shows configuration of the full 24 timeslots on the 2-Port Channelized OC-12/DS0
SPA, which is required when configuring link noise monitoring:
RP/0/RSP0/CPU0:router(config)# controller t1 0/6/0/0/10
RP/0/RSP0/CPU0:router(config-t1e1)# channel-group 5
RP/0/RSP0/CPU0:router(config-t1e1-channel_group)# timeslots 1-24
Related Commands
DescriptionCommand
Selects the frame type for an E1 data line.framing (E1), on page 1002
Selects the frame type for a T1 data line.framing (T1), on page 1006
Specifies the speed of the underlying DS0s in a channel group.speed (DS0), on page 1067
Configures a DS0 channel group and enters channel group
configuration mode.
channel-group, on page 957
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1070
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
timeslots
To Next Page
Loading...
Need help?
General
