DescriptionField
Displays the following internal information for the
interface:
• Operational Mode—Current operation mode
for this controller. Can be WAN mode or LAN
mode.
• Current Alarms—Bit map of all currently active
alarms on this controller. Use this information
for debugging purposes.
Alarms are applicable only when the
controller is configured in WAN-PHY mode.
Note
Internal Information
The following example shows sample output from the show controllers wanphy command with the alarms
keyword:
RP/0/RSP0/CPU0:router# show controllers wanphy 0/3/4/0 alarms
Interface: wanphy0_3_4_0
Configuration Mode: WAN Mode
SECTION
LOF = 1, LOS = 1, BIP(B1) = 2912
LINE
AIS = 1, RDI = 0, FEBE = 949, BIP(B2) = 48562
PATH
AIS = 1, RDI = 0, FEBE = 0, BIP(B2) = 0
LOP = 0, NEWPTR = 0, PSE = 0, NSE = 0
WIS ALARMS
SER = 9, FELCDP = 0, FEAISP = 0
WLOS = 1, PLCD = 0
LFEBIP = 47260, PBEC = 949
Active Alarms[All defects]:
Active Alarms[Highest Alarms]:
Rx(K1/K2): N/A, Tx(K1/K2): N/A
S1S0 = N/A, C2 = N/A
PATH TRACE BUFFER
Remote IP addr: 981.761.542.321
BER thresholds: N/A
TCA thresholds: N/A
The alarm information displayed in the show controllers wanphy interface-id alarms command output are
described in Table 65: show controllers wanphy Command Output Fields, on page 1107.
Related Commands
DescriptionCommand
Clears the alarms counters for a specific 10-Gigabit Ethernet
WAN PHY controller.
clear controller wanphy, on page 1096
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1113
10-Gigabit Ethernet WAN PHY Controller Commandson the Cisco ASR 9000 Series Router
show controllers wanphy
To Next Page
Loading...
Need help?
General
