Task ID
OperationsTask ID
readinterface
Examples
The following example shows how to display information about a multilink interface:
RP/0/RSP0/CPU0:router# show interfaces multilink 0/1/0/0/1
Multilink0/1/0/0/1 is up, line protocol is up
Interface state transitions: 1
Hardware is Multilink network interface(s)
Internet address is 10.1.1.1/24
MTU 1504 bytes, BW 1536 Kbit
reliability 255/255, txload 3/255, rxload 3/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
LCP Open
Open: IPCP
Last input 00:00:00, output 00:00:00
Last clearing of "show interface" counters 02:06:24
5 minute input rate 19000 bits/sec, 5 packets/sec
5 minute output rate 19000 bits/sec, 5 packets/sec
48769 packets input, 12425740 bytes, 0 total input drops
0 drops for unrecognized upper-level protocol
Received 0 runts, 0 giants, 0 throttles, 0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
67905 packets output, 17400050 bytes, 0 total output drops
0 output errors, 0 underruns, 0 applique, 0 resets
0 output buffer failures, 0 output buffers swapped out
Fragmentation Statistics
Input Fragmented packets 0 Input Fragmented bytes 0
Output Fragmented packets 0 Output Fragmented bytes 0
Input Unfragmented packets 0 Input Unfragmented bytes 0
Output Unfragmented packets 0 Output Unfragmented bytes 0
Input Reassembled packets 0 Input Reassembled bytes 0
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
691
Multilink Commands on the Cisco ASR 9000 Series Router
show interfaces multilink
To Next Page
Loading...
Need help?
General
