Examples
This example shows how to display the number of sessions in each ICSSO state for each session layer.
RP/0/RSP0/CPU0:router# show ppp sso summary location 0/3/cpu0
Not-Ready : The session is not yet ready to run as Active or Standby
Stby-UnNegd : In Standby mode, no replication state received yet
Act-Down : In Active mode, lower layer not yet up
Deactivating : Session was Active, now going Standby
Act-UnNegd : In Active mode, not fully negotiated yet
Stby-Negd : In Standby mode, replication state received and pre-programmed
Activating : Session was Standby and pre-programmed, now going Active
Act-Negd : In Active mode, fully negotiated and up
- : This layer not running
Not- Stby- Act- Deactiv- Act- Stby- Activ- Act
Layer | Total Ready UnNegd Down ating UnNegd Negd ating Negd
-------------+------- ------ ------ ------ ------ ------ ------ ------ -----
LCP | 20 2 5 0 0 3 6 0 4
of-us-auth | 20 10 2 0 0 1 4 0 3
of-peer-auth | 20 10 3 0 0 2 3 0 2
IPCP | 10 1 2 1 0 3 2 0 1
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
770
PPP Commands onthe Cisco ASR 9000 Series Router
show ppp sso summary
To Next Page
Loading...
Need help?
General
