Examples
The following example shows how to attach an IP header compression (IPHC) profile to an interface.
RP/0/RSP0/CPU0:router(config)# config
RP/0/RSP0/CPU0:router(config)# interface serial 0/1/0/1
RP/0/RSP0/CPU0:router(config-if)# ipv4 iphc profile Profile_1
The following example shows how to attach an IPHC profile that applies to a QoS service policy to an interface:
RP/0/RSP0/CPU0:router(config)# config
RP/0/RSP0/CPU0:router(config)# interface serial 0/1/0/1
RP/0/RSP0/CPU0:router(config-if)# ipv4 iphc profile Profile_1 mode service-policy
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
794
Serial Interface Commands on the Cisco ASR 9000 Series Router
ipv4 iphc profile
To Next Page
Loading...
Need help?
General
