Related Commands
DescriptionCommand
Manually switches an APS channel.aps group, on page 839
Configures the authentication string for the PGP message exchange
between the protect and working routers.
authenticate (PGP), on page 846
Assigns local SONET physical ports as SONET APS channels in the
current APS group.
channel local, on page 849
Assigns a port and interface that is physically located in a remote router
as a SONET working or protect APS channel.
channel remote, on page 851
Overrides a manual or forced APS request at the local end of the SONET
link and block the protect channel from receiving traffic.
lockout, on page 870
Enables automatic switchover from the protect interface to the working
interface after the working interface becomes available.
revert, on page 890
Configures the K1K2 overhead byte signaling protocol used for APS.signalling, on page 918
Changes the time between hello packets and the time before the protect
interface process declares a working interface router to be down.
timers (APS), on page 921
Configures a protect interface for unidirectional mode.unidirectional, on page 930
Displays the operational status for all configured SONET APS groups.show aps, on page 893
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
843
SONET Controller Commands on the Cisco ASR 9000 Series Router
aps group (global)
To Next Page
Loading...
Need help?
General
