EasyManuals Logo

Cisco A9K-SIP-700 Command Reference Guide

Cisco A9K-SIP-700
1138 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #878 background imageLoading...
Page #878 background image
â—¦
port: Physical port number of the interface.
•
If specifying a virtual interface, the number range varies, depending on interface type.
Use the path (SONET) command to enter SONET/SDH path configuration mode to specify other SONET
options for a SONET path.
Task ID
Examples
The following example shows how to enter SONET/SDH configuration mode for the SONET controller in
slot number 2:
RP/0/RSP0/CPU0:router(config)# controller SONET 0/2/0/1
RP/0/RSP0/CPU0:router(config-sonet)#
The following example shows how to configure the SONET controller path (0/2/0/1) to send a path-level
remote defect indication (PRDI) when the bit error rate (BER) bit interleaved parity (BIP) B3 threshold is
exceeded. :
RP/0/RSP0/CPU0:router(config)# controller SONET 0/2/0/1 path b3-ber-prdi
RP/0/RSP0/CPU0:router(config-sonet)#
Related Commands
DescriptionCommand
Enters SONET/SDH path configuration mode.path (SONET), on page 884
Displays information about the operational status of SONET
layers.
show controllers sonet, on page 906
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
858
SONET Controller Commands on the Cisco ASR 9000 Series Router
controller (SONET)

Table of Contents

Other manuals for Cisco A9K-SIP-700

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco A9K-SIP-700 and is the answer not in the manual?

Cisco A9K-SIP-700 Specifications

General IconGeneral
BrandCisco
ModelA9K-SIP-700
CategoryNetwork Router
LanguageEnglish

Related product manuals