Cisco A9K-SIP-700 Command Reference Guide

Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
For the interface-path-id argument, use the following guidelines:
•
If specifying a physical interface, the naming notation is rack/slot/module/port. The slash between values
is required as part of the notation. An explanation of each component of the naming notation is as follows:
◦
rack: Chassis number of the rack.
◦
slot: Physical slot number of the line card.
◦
module: Module number. A physical layer interface module (PLIM) is always 0.
◦
port: Physical port number of the interface.
•
If specifying a virtual interface, the number range varies, depending on interface type.
The information displayed is generally useful for diagnostic tasks performed by technical support personnel
only.
Task ID
OperationsTask ID
readinterface
Examples
The following is sample output from the show controllers pos command:
RP/0/RSP0/CPU0:router# show controllers POS 0/3/0/2
Port Number : 2
Interface : POS0/3/0/2
Ifhandle : 0x1380120
CRC : 32
MTU : 4474
Port Bandwidth Kbps : 2488320
Admin state : Up
Driver Link state : Up
Bundle member : No
Bundle MTU : 4474
Bundle Adminstate : Up
The following is sample output from the show controllers pos all command:
RP/0/RSP0/CPU0:router# show controllers POS 0/3/0/2 all
Port Number : 2
Interface : POS0/3/0/2
Ifhandle : 0x1380120
CRC : 32
MTU : 4474
Port Bandwidth Kbps : 2488320
Admin state : Up
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
901
SONET Controller Commands on the Cisco ASR 9000 Series Router
show controllers pos

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English