Examples
The following example shows how to insert 10 errors into the BERT bit stream on the T3 controller in slot
0, subslot 3:
RP/0/RSP0/CPU0:router(config)# controller t3 0/0/3/1/10
RP/0/RSP0/CPU0:router(config-t3e3)# bert error 10
Related Commands
DescriptionCommand
Specifies the duration of a bit error rate test (BERT) pattern on a
T3/E3 or T1/E1 line.
bert interval, on page 945
Enables a BERT pattern on a T3/E3 or T1/E1 line or an individual
channel group.
bert pattern, on page 947
Displays information about the E1 links and hardware and software
drivers for the E1 controller.
show controllers e1, on page 1034
Displays information about the E3 links and hardware and software
drivers for the E3 controller.
show controllers e3, on page 1038
Displays information about the T1 links and hardware and software
drivers for the T1 controller.
show controllers t1, on page 1046
Displays information about the T3 links and hardware and software
drivers for the T3 controller.
show controllers t3, on page 1054
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
944
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
bert error
To Next Page
Loading...
Need help?
General
