Examples
The following example shows how to limit the BERT to 10 minutes on the T3 controller in slot 0, subslot 3:
RP/0/RSP0/CPU0:router(config)# controller t3 0/0/3/1/10
RP/0/RSP0/CPU0:router(config-t3e3)# bert interval 10
Related Commands
DescriptionCommand
Insert errors into a BERT stream on a T3/E3 or T1/E1 line.bert error, on page 943
Enables a BERT pattern on a T3/E3 or T1/E1 line or an individual
channel group.
bert pattern, on page 947
Displays information about the E1 links and hardware and software
drivers for the E1 controller.
show controllers e1, on page 1034
Displays information about the E3 links and hardware and software
drivers for the E3 controller.
show controllers e3, on page 1038
Displays information about the T1 links and hardware and software
drivers for the T1 controller.
show controllers t1, on page 1046
Displays information about the T3 links and hardware and software
drivers for the T3 controller.
show controllers t3, on page 1054
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
946
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
bert interval