The only available command is “run.”
24.A new drop-down menu appears to let you choose the next part of the command.
You can run a macro or a preset.
25.A new drop-down menu appears to let you choose which macro or preset you want to run.
26.Click OK.
The completed command appears in the Command column.
27.Repeat steps 22-26 for Low.
Divider Pin High
28.If you have chosen a divider, rather than a partition, as your Allocate To selection, the following options
appear:
29.Click Closed or Open to set the value of the pin.
To Next Page
