CONSOLE AI | Managing Channels (CP2) | 212
8. Change any of the options, as described in the table below:
Option Description
Enabled Whether or not the signal generator is enabled.
Signal Type Choose from the following options:
• Logarithmic Swept Sine Wave-A test signal increasing in frequency using
exponential steps (i.e., rises on a curve).
• Tone-A sine-wave test with less than .03% distortion. When using Tone you
specify a frequency.
• White-A test signal with equal energy distribution throughout a given frequency
range.
• Pink-A test signal containing all the frequencies in a given audio spectrum, with
equal energy in each octave.
Frequency The frequency of the signal. Applies only when the signal type is Tone.
Amplitude The amount of gain, or volume, to use during signal generation.
9. Click Close.
Phantom Power
10.To turn phantom power on or off, click the PPWR button (the button changes to light green if phantom
power is on).
Coarse Gain
11.To change the coarse gain, drag the Coarse Gain slider.
Fine Gain
12.You can change the fine gain in any of the following ways:
• Drag the slider
• Type a value in the text box
• Click the incrementer and decrementer arrows beside the text box to set the value
AEC
13.To turn AEC on or off, click the AEC button (the button changes to light green if AEC is on).
CONSOLE AI User Manual
To Next Page
Loading...
