xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
1048
34-3 config wac authorization attributes
Description
This command is used to configure the acceptance of an authorized configuration. When the
authorization is enabled for WAC’s RADIUS, the authorized data assigned by the RADUIS server will
be accepted if the global authorization network is enabled. When the authorization is enabled for
WAC’s local, the authorized data assigned by the local database will be accepted.
Format
config wac authorization attributes {radius [enable | disable] | local [enable | disable]}(1)
Parameters
radius - If specified to enable, the authorized data assigned by the RADUIS server will be accepted if
the global authorization network is enabled. The default state is enabled.
enable - Specify to enable authorized data assigned by the RADIUS server to be accepted.
disable - Specify to disable authorized data assigned by the RADIUS server from being accepted.
local - If specified to enable, the authorized data assigned by the local database will be accepted if
the global authorization network is enabled. The default state is enabled.
enable - Specify to enable authorized data assigned by the local database to be accepted.
disable - Specify to disable authorized data assigned by the local database from being accepted.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the acceptance of an authorized configuration:
DGS-3420-28SC:admin#config wac authorization attributes local disable
Command: config wac authorization attributes local disable
Success.
34-4 config wac ports
Description
This command is used to configure the WAC port parameters.
Format
config wac ports
[<portlist>
| all] {s
tate [enable | disable
] | aging_time
[infinite | <min
1
-1440>] | idle_time [infinite | <min 1-1440>] | block_time [<sec 0-300>]}(1)
To Next Page
Loading...
Need help?
General