D-Link xStack DGS-3420 Series - Show Qinq; Config Qinq Ports

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
816
6-3 show qinq
Description
This command is used to display the global Q-in-Q status.
Format
show qinq
Parameters
None.
Restrictions
None.
Example
To display Q-in-Q:
DGS-3420-28SC:admin#show qinq
Command: show qinq
QinQ Status : Enabled
DGS-3420-28SC:admin#
6-4 config qinq ports
Description
This command is used to configure Q-in-Q port parameters on this Switch.
Format
config qinq ports [<portlist> | all] {role [uni | nni] | missdrop [enable | disable] | outer_tpid <hex
0x1-0xffff>| use_inner_priority [enable | disable] | add_inner_tag [<hex 0x1-0xffff> | disable] |
[add | delete] vlan_translation_profile <profile_id>}(1)
Parameters
<portlist> - Specify a range of ports to configure.
all - Specify to configure all ports.
role - Specify the port role in Q-in-Q mode.
uni - The port is connecting to the customer network.
nni - The port is connecting to the service provider network.
missdrop - Enable or disable the tagged packet drop that does not match any assignment rule in