D-Link xStack DGS-3420 Series - Chapter 39 IGMP Snooping Commands

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
441
Chapter 39 IGMP Snooping
Commands
config igmp_snooping [vlan_name <vlan_name 32> | vlanid <vlanid_list> | all] {state [enable |
disable] | fast_leave [enable | disable] | proxy_reporting {state [enable | disable] | source_ip
<ipaddr>}(1)}(1)
config igmp_snooping querier [vlan_name <vlan_name 32> | vlanid <vlanid_list> | all]
{query_interval <sec 1-65535> | max_response_time <sec 1-25> | robustness_variable
<value 1-7> | last_member_query_interval <sec 1-25> | state [enable | disable] | version
<value 1-3>}(1)
config router_ports [<vlan_name 32> | vlanid <vlanid_list>] [add |delete] <portlist>
config router_ports_forbidden [<vlan_name 32> | vlanid <vlanid_list>] [add | delete] <portlist>
show router_ports [vlan <vlan_name 32> | vlanid <vlanid_list> | all] {[static | dynamic | forbidden]}
enable igmp_snooping
disable igmp_snooping
show igmp_snooping {[vlan <vlan_name 32> | vlanid <vlanid_list>]}
show igmp_snooping group {[vlan <vlan_name 32> | vlanid <vlanid_list> | ports <portlist>]
{<ipaddr>}} {data_driven}
config igmp_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-1000> |
no_limit]
show igmp_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>]
create igmp_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipaddr>
config igmp_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipaddr> [add |
delete] <portlist>
delete igmp_snooping static_group [vlan <vlan_name 32> | vlanid <vlanid_list>] <ipaddr>
show igmp_snooping static_group {[vlan <vlan_name 32> | vlanid <vlanid_list>] <ipaddr>}
show igmp_snooping statistic counter [vlan <vlan_name 32> | vlanid <vlanid_list> | ports
<portlist>]
clear igmp_snooping statistics counter
show igmp_snooping forwarding {[vlan <vlan_name 32> | vlanid <vlanid_list>]}
clear igmp_snooping data_driven_group [all | [vlan_name <vlan_name 32> | vlanid
<vlanid_list>] [<ipaddr> | all]]
config igmp_snooping data_driven_learning [all | vlan_name <vlan_name 32> | vlanid
<vlanid_list>] {state [enable | disable] | aged_out [enable | disable] | expiry_time <sec 1-
65535>}
config igmp_snooping data_driven_learning max_learned_entry <value 1-960>
config igmp_snooping forward_lookup_mode [ip | mac]
show igmp_snooping forward_lookup_mode
config igmp access_authentication ports [all | <portlist>] state [enable {[auth_accounting |
auth_only | accounting_only]} | disable]
show igmp access_authentication ports [all | <portlist>]
39-1 config igmp_snooping
Description
This command is used to configure IGMP snooping on the switch.