D-Link xStack DGS-3420 Series - Chapter 31 Energy Efficient Ethernet (EEE) Commands

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
394
Chapter 31 Energy Efficient
Ethernet (EEE) Commands
Note: This feature is only available on hardware version B1 and later
config eee ports [<portlist> | all] state [enable | disable]
show eee ports {<portlist>}
31-1 config eee ports
Description
This command is used to enable or disable the EEE function on the specified port(s) on the Switch.
Format
config eee ports [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Specify a range of ports to be configured.
all - Specify to configure all ports.
state - Specify the EEE state. The default is disabled.
enable - Enable the EEE function for the specified port(s).
disable - Disable the EEE function for the specified port(s).
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable the EEE state on ports 1:2-1:5:
DGS-3420-28SC:admin#config eee ports 1:2-1:5 state enable
Command: config eee ports 1:2-1:5 state enable
Success.
DGS-3420-28SC:admin#