xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
396
Chapter 32
Ethernet Ring
Protection Switching
(ERPS) Commands
create erps raps_vlan <vlanid 1-4094>
delete erps raps_vlan <vlanid 1-4094>
config erps raps_vlan <vlanid> [state [enable | disable] | ring_mel <value 0-7> | ring_port [west
[<port> | virtual
_channe
l] | east [<port> | virtual_ch
annel]] | rpl_port [w
est | east | none] |
rpl_owner [enable | disable] | protected_vlan [add | delete] vlanid <vidlist> | sub_ring raps_vlan
<vlanid> tc_propagation state [enable | disable] | [add | delete] sub_ring raps_vlan <vlanid> |
revertive [enable | disable] | timer {holdoff_time <millisecond 0-10000> | guard_time <millisecond
10-2000> | wtr_time <min 5-12>}(1)]
config erps log [enable | disable]
config erps trap [enable | disable]
show erps {raps_vlan <vlanid 1-4094> {sub_ring}}
32-1 enable erps
Description
This command is used to enable the ERPS function on a switch. STP and LBD should be disabled on
the ring ports before enabling ERPS. ERPS cannot be enabled before the R-APS VLAN is created,
and ring ports, an RPL port, an RPL owner, are configured. In order to guarantee correct operation,
the following integrity will be checked when ERPS is enabled:
1. R-APS VLAN is created.
2. The Ring port is a tagged member port of the R-APS VLAN.
3. The RPL port is specified if the RPL owner is enabled.
4. The RPL port is not virtual channel.
5. The Ring port is the master port if it belongs to a link aggregation group.
Format
enable erps
Parameters
None.
To Next Page
Loading...
Need help?
General