To Next Page

To Previous Page

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide

477

Chapter 41

IPv4/IPv6 Routing

Commands

create iproute [default | <network_address>] [<ipaddr> {<metric 1-65535>} {[primary | backup]} |

null0 | ip_tunnel <tunnel_name 12>]

delete iproute [default | <network_address>] [<ipaddr> | null0 | ip_tunnel <tunnel_name 12>]

show iproute {[<network_address> | <ipaddr>]} {[static | rip | hardware]}

create ipv6route [default | <ipv6networkaddr>] [[<ipif_name 12> <ipv6addr> | <ipv6addr>]

{<metric 1-65535>} {[primary | backup]} | ip_tunnel <tunnel_name 12>]

delete ipv6route [[default | <ipv6networkaddr>] [<ipif_name 12> <ipv6addr> | <ipv6addr> |

ip_tunnel <tunnel_name 12>] | all]

show ipv6route {[<ipv6networkaddr> | <ipv6addr>]} {[static | ripng | hardware]}

create ipv6route redistribute dst ripng src [local | static] {metric <value 0-16>}

config ipv6route redistribute dst ripng src [local | static] {metric <value 0-16>}

delete ipv6route redistribute dst ripng src [local | static]

41-1 create iproute

Description

This command is used to create an IP route entry in the Switch’s IP routing table. “Primary” and

“backup” are mutually exclusive. Users can select only one when creating one new route. If a user

sets neither of these, the system will try to set the new route first by primary and second by backup.

Format

create iproute [default | <network_address>] [<ipaddr> {<metric 1-65535>} {[primary | backup]} |

null0 | ip_tunnel <tunnel_name 12>]

Parameters

default - Create a default IP route entry.

<network_address> - The IP address and netmask of the IP interface that is the destination of

the route. Specify the address and mask information using the traditional format (for example,

10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/16).

<ipaddr> - Specifies the IP address for the next hop router.

<metric 1-65535> - (Optional) The default setting is 1.That is, the default hop cost is 1.

primary - (Optional) Specifies the route as the primary route to the destination.

backup - (Optional) Specifies the route as the backup route to the destination. If the route is

not specified as the primary route or the backup route, then it will be auto-assigned by the

system. The first created is the primary, the second created is the backup.

null0 - Specifies the null interface as the next hop.

ip_tunnel - Specifies the IP tunnel used.

<tunnel_name 12> - Enter the IP tunnel name used here. This name can be up to 12

characters long.

D-Link xStack DGS-3420 Series User Manual

Questions and Answers: