D-Link xStack DGS-3420 Series - Config Accounting Service

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
99
radius - Specifies to use the built-in server group 'radius'.
server_group - Specifies the user-defined server group. If the group contains 'tacacs' or
'xtacacs' server, it will be skipped in accounting.
<string 15> - Enter the user-defined server group name here. This name can be up to 15
characters long.
none - Specifies no accounting.
Restrictions
Only Administrator level users can issue this command.
Example
To configure a user-defined method list called “shell_acct”, that specifies a sequence of the built-in
“tacacs+” server group, followed by the “radius” server group for accounting service on switch:
DGS-3420-28SC:admin#config accounting method_list_name shell_acct method tacacs+
radius
Command: config accounting method_list_name shell_acct method tacacs+ radius
Success.
DGS-3420-28SC:admin#
4-51 config accounting service
Description
This command is used to configure the state of the specified RADIUS accounting service.
Format
config accounting service [network | shell | system] state [enable {[radius_only |
method_list_name <string 15> | default_method_list]} | disable]
Parameters
network - Specifies that when enabled, the Switch will send informational packets to a remote
RADIUS server when 802.1X, WAC and JWAC port access control events occur on the Switch.
By default, the service is disabled.
shell - Specifies that when enabled, the Switch will send informational packets to a remote RADIUS
server when a user either logs in, logs out or times out on the Switch, using the console, Telnet, or
SSH. By default, the service is disabled.
system - Specifies that when enabled, the Switch will send informational packets to a remote
RADIUS server when system events occur on the Switch, such as a system reset or system boot.
By default, the service is disabled.
state - Specify the state of the accounting service.
enable - Enable the specified accounting service.
radius_only - Specifies that the accounting service should only use the RADIUS group
specified by the config radius add <server_index 1-3> [<server_ip> | <ipv6addr>]”
command.