xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
1049
Parameters
<portlist> - Specify a range of ports to configure.
all - Specify to configure all ports.
state - Specify to enable or disable the WAC state.
enable - Specify to enable the WAC state.
disable - Specify to disable the WAC state.
aging_time - Specify a time period during which an authenticated host will be kept in authenticated
state. The default value is 1440 minutes.
infinite - Specify to indicate the authenticated host on the port will not ageout.
<min 1-1440> - Specify an ageout value between 1 and 1440 minutes.
idle_time - Specify a time period after which an authenticated host will be moved to un-authenticated
state if there is no traffic during that period. The default value is infinite.
infinite - Specify to indicate the host will not be removed from the authenticated state due to idle
of traffic.
<min 1-1440> - Specify an idle time between 1 and 1440 minutes.
block_time - If a host fails to pass the authentication, it will be blocked for this period of time before it
can be re-authenticated.The default value is 60 seconds.
<sec 0-300> - Specify a block time between 0 and 300 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the WAC port state:
DGS-3420-28SC:admin#config wac ports 1-8 state enable
Command: config wac ports 1-8 state enable
Success.
To configure the WAC port aging time:
DGS-3420-28SC:admin#config wac ports 1-5 aging_time 200
Command: config wac ports 1-5 aging_time 200
Success.
34-5 config wac method
Description
This command is used to allow specification of the RADIUS protocol used by WAC to complete
RADIUS authentication. WAC shares other RADIUS configuration with 802.1X. When using this
To Next Page
Loading...
Need help?
General