D-Link xStack DGS-3420 Series User Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
604
Format
config loopdetect vlan [<vid_list> | all] state [enable | disable]
Parameters
<vid_list> - Enter the VLAN ID, used for this configuration, here.
all - Specifies that all VLANs will be used for this configuration.
state - Specifies whether the LBD function should be enabled or disabled on the VLANs specified
in the VLAN ID list. The default state is enabled.
enable - Specifies that the LBD function will be enabled.
disable - Specifies that the LBD function will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the LBD function on VLANs 2 to 5:
DGS-3420-28SC:admin#config loopdetect vlan 2-5 state enable
Command: config loopdetect vlan 2-5 state enable
Success.
DGS-3420-28SC:admin#
52-4 enable loopdetect
Description
This command is used to allow the loop detection function to be globally enabled on the switch. The
default value is disabled.
Format
enable loopdetect
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.

D-Link xStack DGS-3420 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3420 Series
Category	Switch
Language	English