D-Link xStack DGS-3420 Series - Config Gvrp

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
1030
DGS-3420-28SC:admin#
32-8 show port_vlan
Description
This command is used to display the GVRP status for a port list on the switch.
Format
show port_vlan {<portlist>}
Parameters
<portlist> - (Optional) Specify a range of ports to be displayed.
Note: If no parameter is specified, the system will display GVRP information for all ports.
Restrictions
None.
Example
To display 802.1q port settings for ports 1 to 3:
DGS-3420-28SC:admin#show port_vlan 1-3
Command: show port_vlan 1-3
Port PVID GVRP Ingress Checking Acceptable Frame Type
------- ---- -------- ---------------- ----------------------------
1 1 Disabled Enabled All Frames
2 1 Disabled Enabled All Frames
3 1 Disabled Enabled All Frames
Total Entries : 3
DGS-3420-28SC:admin#
32-9 config gvrp
Description
This command is used to set the GVRP timer’s value.