D-Link xStack DGS-3420 Series - Debug Stp State

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
255
19-14 debug stp state
Description
This command is used to enable or disable the STP debug state.
Format
debug stp state [enable | disable]
Parameters
state - Specifies the STP debug state.
enable - Enable the STP debug state.
disable - Disable the STP debug state.
Restrictions
Only Administrator level users can issue this command.
Example
To configure the STP debug state to enable, and then disable the STP debug state:
DGS-3420-28SC:admin# debug stp state enable
Command: debug stp state enable
Success.
DGS-3420-28SC:admin# debug stp state disable
Command: debug stp state disable
Success.
DGS-3420-28SC:admin#
19-15 debug dhcpv6_client state enable
Description
This command is used to enable the DHCPv6 client Debug function.
Format
debug dhcpv6_client state enable