D-Link xStack DGS-3420 Series - Config Igmp_Snooping Rate_Limit [Ports <Portlist> | Vlanid <Vlanid_List>] [<Value 1-1000> | No_Limit]

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
451
39-10 config igmp_snooping rate_limit
Description
This command is used to configure the upper limit per second for ingress IGMP control packets.
Format
config igmp_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-1000> |
no_limit]
Parameters
ports - Specify a range of ports to be configured.
<portlist> - Specify a range of ports to be configured.
vlanid - Specify a range of VLANs to be configured.
<vlanid_list> - Specify the VLAN ID list.
<value 1-1000> - Specify the rate of IGMP control packets that the switch can process on a specific
port/VLAN. The rate is specified in packet per second. The packets that exceed the limited rate
will be dropped.
no_limit - The default setting is no limit.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the IGMP snooping rate limit for ports 1-2 to have no limit:
DGS-3420-28SC:admin#config igmp_snooping rate_limit ports 1-2 no_limit
Command: config igmp_snooping rate_limit ports 1-2 no_limit
Success.
DGS-3420-28SC:admin#
39-11 show igmp_snooping rate_limit
Description
This command is used to display the IGMP snooping rate limit setting.
Format
show igmp_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>]