xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
80
Format
config authen parameter attempt <int 1-255>
Parameters
<int 1-255> - Specify the amount of attempts for users trying to login or promote the privilege on
console, Telnet, or SSH. The default value is 3.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure the maximum attempts for users trying to login or promote the privilege to be 9:
DGS-3420-28SC:admin#config authen parameter attempt 9
Command: config authen parameter attempt 9
Success.
4-26 show authen parameter
Description
This command is used to display the authentication parameters.
Format
show authen parameter
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To display the authentication parameters:
DGS-3420-28SC:admin# show authen parameter
To Next Page
Loading...
