xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
245
DGS-3420-28SC:admin# debug error_log upload_toTFTP 10.0.0.90 debug-log.txt
Command: debug error_log upload_toTFTP 10.0.0.90 debug-log.txt
Connecting to server................... Done.
Upload configuration................... Done.
19-4 debug buffer
Description
Use this command to show the debug buffer’s state, or dump, clear, or upload the debug buffer to a
TFTP server.
Note: When selecting to output to the debug buffer and there are debug messages being
outputted, the system memory pool will be used as the debug buffer. The functions
which will use the system memory pool resource may fail to execute command such
as download and upload firmware, or save configuration. If you want to execute these
commands successfully, please use the command “debug buffer clear” to release the
system’s memory pool resources manually first.
Format
debug buffer [u
tilization
| dump | clear | upl
oad_toTFTP <ipad
dr> <path_fil
ename 64>]
Parameters
utilization - Display the debug buffer’s state.
dump - Display the debug message in the debug buffer.
clear - Clear the debug buffer.
upload_toTFTP - Upload the debug buffer to a TFTP server specified by IP address.
<ipaddr> - Specifies the IPv4 address of the TFTP server.
<path_filename 64> - The pathname specifies the DOS pathname on the TFTP server. It can be
a relative pathname or an absolute pathname. This value can be up to 64 characters long.
Restrictions
Only Administrator level users can issue this command.
Example
To show the debug buffer’s state:
To Next Page
Loading...
Need help?
General