D-Link xStack DGS-3420 Series - Config Ssh Server

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
917
DGS-3420-28SC:admin#show ssh user authmode
Command: show ssh user authmode
Current Accounts:
User Name Authentication Host Name Host IP
--------------- --------- -------------------------------- ---------------
dlink Host-based dlink.com 192.168.69.1
dlink2 Host-based dlink.com
dlink3 Password
Total Entries : 3
DGS-3420-28SC:admin#
17-7 config ssh server
Description
This command is used to configure SSH server general information.
Format
config ssh server {maxsession <int 1-8> | contimeout <sec 30-600> | authfail<int 2-20> | rekey
[10min | 30min | 60min | never] | port <tcp_port_number 1-65535>}(1)
Parameters
maxsession - Specify the SSH server maximum session at the same time.
<int 1-8> - Specify the SSH server maximum session at the same time. The maximum session
value must be between 1 and 8. The default value is 8.
contimeout - Specify the SSH server connection timeout.
<sec 30-600> - Specify the SSH server connection timeout. The connection timeout value must
be between 30 and 600 seconds. The default value is 120 seconds.
authfail - Specify the user maximum fail attempts.
<int 2-20> - Specify the user maximum fail attempts. The maximum authentication fail attempts
must be between 2 and 20. The default value is 2.
rekey - (Optional) Specify the time to re-generate the session key.
10min - Specify 10 minutes to re-generate the session key.
30min - Specify 30 minutes to re-generate the session key.
60min - Specify 60 minutes to re-generate the session key.
never - Do not re-generate the session key.
port - Specify a TCP port number between 1 and 65535.
<tcp_port_number 1-65535> - Specify a TCP port number between 1 and 65535.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.