D-Link xStack DGS-3420 Series - Config Snmp Engineid

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
887
Format
create snmp community_masking view <view_name 32> [read_only | read_write]
Parameters
<view_name 32> - Enter the MIB view name used here. This name can be up to 32 characters long.
read_only - Specifies that the user, using the community string, will have read only access to the
switch’s SNMP agent.
read_write - Specifies that the user, using the community string, will have read/write access to the
switch’s SNMP agent.
Restrictions
Only Administrator level users can issue this command.
Example
To create an SNMP community string called “community123” with the “read_only” security method:
DGS-3420-28SC:admin# create snmp community_masking view CommunityView read_only
Command: create snmp community_masking view CommunityView read_only
Enter a case-sensitive community:************
Enter the community again for confirmation:************
Success.
DGS-3420-28SC:admin#
15-12 config snmp engineID
Description
This command is used to configure an identifier for the SNMP engine on the switch. Associated with
each SNMP entity is a unique engine ID.
Format
config snmp engineID <snmp_engineID 10-64>
Parameters
<snmp_engineID 10-64> - Specify the identify for the SNMP engine on the switch.
Restrictions
Only Administrator-level users can issue this command.